Saturday, 3 September 2016

Fur Design

BEADED FUR DESIGN
Materials:
Sandbead(sb): Size 2
Fishing Line: 0.30/0.35mm
Beading needle: Size 12
Procedure:
Step 1:
String 11 SB and form a circle .
Then pass through thr next 3 SB with
your right hand.
Where u exited, string 5 SB and pass back
through d bead u exited to form a loop.
Pass again through the next three SB and
form another loop of five SB there.
Continue till u have formed four loops.
Step 2:
At the last place where u formed a loop,
string 3 SB using your needle
And pass thru d bead u use to form a
loop.
Then string another 3 SB and pass
through d next bead u used in forming
the loop. Do that to all d four loops.
I.e…. The four loops should be having
three SB in between.
Step 3:
After the last loop, Pass through the next
two SB. This means that your needle will
be exiting on the second bead of the
three u strung.
When u exit, string 5 SB on that second
bead and form another loop there.
After that, pass through only the second
bead of the second loop and form another
loop of five SB there. Continue till u have
done same to all four loops.
The trick is that on each second SB u will
always form a loop there. And after u
have formed a loop, before u proceed to
the next second bead u must string three
SB. That way when u are through u will
always have second bead to form a loop.
When u have done this several times, u
increase the SB in the loop to 7, 9, 11, etc
depending on how big u want it. But the
three remains the same. U have to string
three before going to d second to form a
loop.
NB:- I will appreciate if u can upload ur design to the page ,,, so I can know if people are really following or practising our tutorial.....

No comments:

Post a Comment